Asko WMC Service Manual download pdf (Page 63)

SERVICE

CROSS MEMBER

Changing the input terminal block

1. Remove the top cover by first removing the 3

screws at the rear edge and then lifting the cover

off.

2. Remove the earthing screw.

3. Disconnect all the wiring.

4. Press the latches in with a screwdriver and pull

out the input terminal block.

NOTE

Make sure that the wires are connected correctly

when changing the input terminal block and the

connection cables.

5. Install the new input terminal block, the lat-

ches must clip on to the edge of the plate.

6. Install the wiring in accordance with the elec-

trical schematic diagram.

7. Secure the earthing screw.

IMPORTANT

Don't forget to put the earthing screw back.

8. Fit the top cover.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 83 84

No comments

Asko WMC Service Manual Page 63