Asko WMC Service Manual download pdf (Page 38)

SERVICE

Changing the motor control board

1. Remove the rear panel by first removing the

12 screws around it and then lifting it off.

2. Remove the securing screw for the motor con-

trol board holder and lift it out.

3. Cut the cabletie and remove the terminal

block.

4. Remove the motor control board by pressing

in the 2 plastic clips that secure the board.

5. Remove the other terminal block and change

the board.

6. Connect the wiring and the 2 terminal blocks.

7. Offer up the board to the holder and press it

into place.

8. Refit the holder and secure it with the screw.

9. Secure the cable clamp.

10. Fit the rear panel.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 83 84

No comments

Asko WMC Service Manual Page 38