Asko WM70 Service Manual download pdf (Page 18)

Service manual WM70

18

Fault indications WM70.2

Error messages Cause Action

Over ﬂow fault Too much water in the

machine.

Service action:

Check the machine’s level system, inlet valve

and drain pump. Make sure that there is no

leaks.

The drain pump is on,

without any water in the

machine.

Service action:

The overﬂow protection at the bottom of

the machine is activated (not all models).

Make sure that there is no leaks (water on

the machines base)

Water outlet fault 1. The drain pump has

been activated more

than 3 minutes. There is

still water in the machine.

2. The wash cycle is

interrupted and the

program is cleared.

Customer information:

1. Check that no objects are stuck in the

drainage hose outlet.

2. Check that the drain pump is not blocked

by foreign objects.

3. Check that there are no kinks in the

drainage hose.

Service action:

1. If the pump only runs for a short while

(approximately 20 seconds), this indicates

a fault in the level system. Check the level

sensor and hoses.

2. Check wiring and voltage to the pump. If

necessary, replace the pump and/or control

3. After implementing corrective action, run

the Drain program or press the Key button

(door open) to empty the machine.

Water inlet fault If the correct water level

is not reached within 5

minutes, the wash cycle

is interrupted.

Customer information:

1. Check that the tap on the water pipe is

open.

Service action:

1. Check that the lter in the machine’s water

intake is not blocked.

2. Check the inlet valve. If necessary, replace

the valve.

3. Check voltage to the inlet valve. If there is

no voltage, this could be due to a fault in the

level system, wiring or control unit.

Security fault The door is open. Close the door

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 47 48

Comments to this Manuals

No comments