Asko WM70 Service Manual download pdf (Page 10)

Service manual WM70

10

Fault indications WM70.1

Error messages on the display Cause Action

F10 – Overﬂow Too much water in the

machine.

Service action:

- Check the machine's level system, inlet valve

and drainage pump.

- Check for any leaks.

The drainage pump is

running but the machine

is empty.

Service action:

- The overﬂow cut-out at the bottom of the

machine has been activated (some models

only).

- Check for leaks.

F11 - Water outlet fault The drainage pump

has been running for 3

minutes. Water remains

in the machine.

The wash cycle has been

interrupted and the

programme reset.

Information to customer:

- Check that no objects are stuck in the

drainage hose outlet.

- Check that the drainage pump is not

blocked by foreign objects.

- Check that there are no kinks in the

drainage hose.

Service action:

- If the pump only runs for a short while

(approximately 20 seconds), this indicates

a fault in the level system. Check the level

sensor and hoses.

- Check wiring and voltage to the pump. If

necessary, replace the pump and/or control

unit. After implementing corrective action,

run the Drain programme or press the

Key (door opening) button to empty the

machine.

F12 – Water inlet fault If the correct water level

is not achieved within 5

minutes the wash cycle

will be interrupted.

Information to customer:

- Check that the tap on the water pipe is open.

Service action:

- Check that the ﬁlter in the machine's water

intake is not blocked.

- Check the inlet valve. If necessary, replace

the valve.

- Check voltage to the inlet valve. If there is

no voltage, this could be due to a fault in

the level system, wiring or control unit.

- Unbalance detection After 10 failed attempets

to spin the load the

machine has stoped to

spin beacuse of to high

umbalance.

Information to customer:

- Small loads with heavy items can cause this

problem when these articles are difﬁcult to

redistribute.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 47 48

Comments to this Manuals

No comments