Asko T700 Operations Instructions Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
Page 4
Different fabrics require different load sizes and drying
temperatures. The table below gives recommended
* Always refer to the care label on the garment to determine if it can be
tumble dried. Some wool and silk and hand-washable items should not
be tumble dried. These items should be removed from the washer then
pressed out in a terry towel to remove excess water before being hung up
or laid flat to dry.
RECOMMENDED RECOMMENDED TEMPERATEMPERATURE SETTINGS TURE SETTINGS AND LOAND LOAD SIZESAD SIZES
temperature settings and load sizes for different fabrics.
TempTemp LoadLoad
Fabric TypeFabric Type SettingSetting SizeSize
Cotton w/out elastic and/or decorative trim Normal Full
Linen – white and colorfast Normal Half
Cotton/polyester blends Low Half
Polyester/acrylic blends Low Half
Rayon and acetate Low Half
Washable silk and nylon * Low Third
Washable wool and wool blends * Low Third
Handwash wool and silk * Low Third
CARE CARE AND MAINTENAND MAINTENANCE INSTRANCE INSTRUCTIONSUCTIONS
CLEANING THE LINT FILTERCLEANING THE LINT FILTER
The wear on fabrics in a tumble dryer is insignificant.
The lint caught in the lint filter is dust and fiber residue
that has been formed when the garments have been
worn. The lint filter must be cleaned after each load. If
this is not done, drying performance will suffer, as
insufficient air will pass through the drum. The machine
may also overheat after a while, which will cause it to
stop automatically.
To clean the lint filter, follow the steps below:
1. Grasp the handle and pull it
toward you.
2. Remove the filter
from the holder.
3. Open the filter and
gently brush away
any lint.
4. Fold the filter
together and return
it to the holder on
the door.
5. Push the holder in
until it snaps into
place.
CLEANING THE EXHAUST HOSECLEANING THE EXHAUST HOSE
About once a year you should remove the exhaust hose
and clean it. At this time, you should also clean the
exhaust outlet on the machine and the ventilation duct.
Periodically, you should check the dryer exhaust outside
to be sure the air flow is strong and nothing is blocking
the vent.
CLEANING CLEANING THE CONTRTHE CONTROL POL PANELANEL
To clean the control panel, use only a soft, warm, damp
(not wet) rag. To prevent penetration of water into the
door lock and electrical components, do not use a spray
cleaner of any kind. Also, never use abrasive cleaners
or scouring pads on the outer surfaces because they
will scratch the finish and possibly remove the writing
on the control panels. Some paper towels may also
scratch the finish.
T720 AND T780 – EMPTYINGT720 AND T780 – EMPTYING
THE THE WWAATER CONTTER CONTAINERAINER
If the dryer is not installed to pump out the condensed
water into a drain or sink, the condensation water collects
in the water container to the left of the control panel. You
should empty the container every three to five dryer
loads, depending on the spin speed you use when you
wash the clothes. For example, clothes spun at 800 rpm
will have more moisture when you take them out of the
washer than clothes spun at 1400 rpm. Therefore, the
dryer will have to remove more water.
1. Pull out the container.
2. Pour out the water.
3. Replace the container.
You should hear it snap
into place.
If the container becomes too full, the machine will shut
down. To restart the program, empty the container and
press Start. It may be a few minutes before the machine
starts because it drains the excess water from the sump
before it restarts.
The condensed water is soft and safe to use
for watering plants.
NOTE:
NOTE:
Do not remove the water container while the
machine is running.
Page view 3
1 2 3 4 5 6 7 8 9 ... 15 16

Comments to this Manuals

No comments