Asko 12004 User Manual download pdf (Page 10)

The machine is supplied with:

• Operating instructions and

instaliation instructions.

• Type-approved inlet hose for

connection to water supply.

• A liquid soap dispenser is

available for thin liquids.

Dimensions 32 1/4" X 23 1/2"

X 23 1/2"

Weight

187.4 lbs.

Drum volume

43 litres

Spinning speed

1300/900 r/min

Rated load

2000/3200 W

Supply voltage

208/240 V,

single-phase

Heater rating

1800/3000 W

Material of drum

and barrel

Stainless steel

Material of

outer casing

Powder-painted

hot-dip-galvanized

steel sheet

Mounting

Stationary: four

adjustable mbber

covered feet

Water supply

hose

63" pex pipe

Supply pressure

0.1-1 MPa

(10-100 N/cm2,

1-10 kp/cm^,

15-142 PSI)

Outlet

59” of poly-

propene hose,

3/4" internal

diameter, max

height of drain

hose 6'

Installation

Removing the transit packing

The transit packing consists of two

tubes which prevent the tub from

moving around inside the machine

during transport. The tubes are

secured to a cross-beam at the

back of the machine.

Remove the transit packing as

foliows:

® Remove the screws and special

washers which retain the beam,

and remove the beam.

' Replace the washers on the flat

tened part of the tubes. Use them

as tools to turn the tubes through

about 45°, as shown in the draw

ing, and pull out the tubes.

Turn

® Turn the washers so that they

cover the holes where the tubes

were fitted and replace the

screws.

Save the tubes and

cross beam, which

wili be needed if the

machine has to be

transported else

where. Fit them in

the reverse order to

that described

above

Adjusting the feet

It is essential that the machine does

not move around when it is spinning.

This means that it must be standing

firmly and level on the floor. The four

feet are individually adjustable. Set

them carefully so that the machine

is standing level, and tighten the

locknuts securely. Failure to do this

will cause unnecessary vibration.

Building-in the machine

The machine can be built in beneath

a standard 331/2--35 1/2"

(850-900 mm) worktop.

There must be at least 1/4" (5 mm) gap

around the machine, also between

the rear edge of the top panel and

the wall behind it. This is important:

if no space is left, the machine may

touch the wall when it starts to spin.

Sere'

Two tubes

inside the

machine

Cross-beam

Washer

NOTE

Height Adjustment:

32 1/4"-331/2"

Do not Raise Higher

than 331/2"

10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments