Asko D5253XXL Service Manual download pdf (Page 11)

Page 11

Customer Care Center

1-800-898-1879

www.askousa.com

TESTING FOR LEAKS

1. Turn on the water supply and check for leaks.

2. Turn the power on at breaker/fuse box and test the

dishwasher operation by running a Rinse cycle. (This

should take about four minutes.)

3. Turn off the electrical power and check for leaks under

the dishwasher and sink.

4. Make sure that no kinks have developed in the drain

lines.

If there are no leaks and the dishwasher seems to be

working properly, continue with the installation.

In order to prevent heat damage to the inlet valve, all

solder connections must be made before the water supply

line is connected.

Flush the water supply line prior to connecting it to the

water fill tube.

The unit has a float switch in the base pan to protect

against flooding. If the inlet valve connection is not seated

properly, water may leak into the base pan and activate

the float switch.

It is important that the water supply line and the shut-off

valve have a sufficient flow volume. At last 3 gallons (12

liters) per minute must be able to pass through the line.

The water pressure should be 4.2-140 psi.

NOTE:

Be sure to run the PEX tubing through the hole to sink

compartment before moving the dishwasher into posi-

tion.

CONNECTING THE WATER SUPPLY

(1) Water supply

(2) Water supply valve (not supplied)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

No comments

Asko D5253XXL Service Manual Page 11