Asko T761 Service Manual download pdf (Page 20)

CUSTOM PANEL DIMENSIONS

WIDTH 23-1/2" (597 mm)*

HEIGHT 30-1/8" (765 mm)

(Measured from the top of

the panel to the lower edge

of the kitchen cabinet.)

THICKNESS 3/4" (19 mm)

WEIGHT Up to 18 lb

Up to 24 lb with accessory

spring

The D3251XLFI and D3531XLFI can only be installed with a fully-integrated, buyer-supplied

custom door panel that extends from the toe kick to the counter top. The unit comes

with everything needed to make installing the door panel easy. The door is predrilled for

the panel’s mounting screws.

The custom panel should be a minimum of 3/4" (19 mm) thick.

Items Provided With The Unit

• Two 3/8" screws

• Four 1-3/4" screws

Planning & Design: Dishwashers

FITTING THE D3251XLFI AND D3531XLFI CUSTOM DOOR PANEL –

4-INCH TOE KICK

Specifications are subject to change without notice. See installation instructions for additional details.

Adjusting The Door Springs

Before you push the dishwasher into the

cabinet opening, test the door to make

sure it stays in place at any angle. If it

tends to fall down, pull out the machine

and adjust the tension of the

door springs on the sides of

the machine by moving

them one hole

farther back or by

twisting the spring

to make it shorter.

Installing The Custom Panel – 4-Inch Toe Kick

Before fitting the custom panel, the dishwasher must be installed

underneath the cabinet. After you’ve made the required measurements,

pull the machine out again to install the panel.

Refer to the illustration at right for instruction references.

1. Fit the handle (A) onto the panel according to the manufacturer’s

instructions. (NOTE: A handle should be used rather than a knob,

because a knob does not provide enough grip.)

WARNING! The custom panel must not obstruct the

fan exhaust vent; otherwise, moisture from the vent

could eventually damage the cabinet and create

drying problems.

2. The two short screws (B) go into the back of the panel, 16-9/16"

(411 mm) from the upper edge of the panel and 5/8" from the outer

edges. Insert the short screws into the panel, leaving 1/8" (3 mm) of

space between the screw head and the panel.

3. Hook the panel screws (D) into the keyholes (C) on the dishwasher door.

4. Pull the panel upwards until the lower edge aligns with the lower edge of the

cabinets and secure the screws.

5. Open the door and use the four screws (D) supplied to secure the panel to the door.

NOTE: If the door panel weighs more than 18 pounds, you may need to order the

heavy-duty door springs. (See page 7.)

*If a wider door panel is required, the side trim strips must be removed.

Shorten

30-1/8"

765 mm

16-9/16"

411 mm

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Comments to this Manuals

No comments

Asko T761 Service Manual Page 20

Comments to this Manuals

Related products and manuals for Electric laundry dryers Asko T761