Asko T761 User Manual download pdf (Page 7)

Page 7

ENGLISH

CONNECTING A 4-WIRE POWER CORD

WARNING!

Before starting this procedure, be sure the

power is turned off at the breaker/fuse box.

Power Supply Cord

You will need a 4-wire power supply cord with four No.

10 copper wires and a matching 4-wire receptacle of

NEMA Type 14-30R, as illustrated below. The fourth wire

must be identified with a green cover and the neutral

conductor by a white cover.

CONNECTING A 3-WIRE POWER CORD

WARNING!

Before starting this procedure, be sure the

power is turned off at the breaker/fuse box.

Power Supply Cord

You will need a 3-wire power supply cord with three No.

10 copper wires and a matching 3-wire receptacle of

NEMA Type 10-30R, as illustrated below:

To connect a 3-wire power cord to the dryer, follow the

steps below.

NOTE: The numbers in the illustration below corre-

late to the step numbers.

1. Turn the power off at the breaker/fuse box.

2. Remove terminal block cover.

3. Use the strain relief attached below the terminal

block opening.

4. Remove center

terminal block screw.

5. Remove ground wire

(green with yellow

stripes) from external

ground connector

screw. Fasten under

center, silver-colored

terminal block screw.

6. Connect ground

(green) wire of cord to

external ground

conductor screw.

7. Connect neutral (white)

wire of cord under

center screw of terminal block.

8. Connect the other wires to outer screws.

9. Tighten the strain relief screws.

10. Replace terminal box cover on back of dryer.

11. Plug dryer into wall receptacle.

12. Turn power on at breaker/fuse box.

To connect a 3-wire power cord to the dryer, follow the

steps below.

NOTE: The numbers in the illustration below corre-

late to the step numbers.

1. Turn the power off at the breaker/fuse box.

2. Remove terminal block cover.

3. Use the strain relief attached below the terminal

block opening.

4. Loosen or remove

center terminal

block screw.

5. Connect neutral

(white ) wire of

power supply cord

to the center, silver-

colored terminal

screw. Tighten

screw.

6. Connect the other

wires to outer

screws.

7. Tighten the strain

relief screws.

8. Replace terminal box cover on back of dryer.

9. Plug dryer into wall receptacle.

10. Turn power on at breaker/fuse box.

1 2 3 4 5 6 7 8 9 10 11 12 ... 25 26

Comments to this Manuals

No comments

Asko T761 User Manual Page 7

Comments to this Manuals

Related products and manuals for Dryers Asko T761