Asko D3152 Use and Care Guide download pdf (Page 32)

Fitting fixed kick-plate

Fitting strip seal

(on floor plinth covering plate)

Proceed as follows:

1. Remove the plastic plinth by gripping with

both hands under the plastic plinth (A), and

break outwards and upwards.

2. Undo the two screws on the covering plate

(B).

3. Glue the accompanying rubber strip (C) to

the underside of the covering plate (against the

floor).

4. Screw the covering plate back into place.

Adjust the covering plate so that the rubber strip

is just in contact with the floor.

5. Replace the plastic plinth

Slide the dishwasher into place

• Pull the drainage hose and connection

pipe when the machine is pushed into

place.

• Check that the hose has no kinks or sharp

bends, and check that there is nothing that

can damage the hoses.

Installing the plinth

(Only with kick-plate as accessory)

The dishwasher has two kick-plates (some

models).

The taller one should be used if the machine is to

be 850 - 870 mm high and the depth of the plinth

can be varied between 45 - 105 mm. The lower

one is to be used if the machine will be 820 - 845

mm with a plinth depth of between 50 - 105 mm.

Attach the enclosed felt insulation to the kick-

plate (some models).

Set the correct plinth depth as follows:

1. Bring the grey hooks towards each other and

pull out the brackets as far as required. Press in

the catches so that

they lock the brackets

in place.

2. Suspend the kick-

plate from the

brackets by pushing

into the slots.

Screw the dishwasher into place

The enclosed plastic plugs are used for cover-

ing the screw holes if the dishwasher is to be

screwed at the sides. After fixing check that the

front feet are in contact with the floor.

Not all models

1 2 ... 27 28 29 30 31 32 33 34 35 36

Comments to this Manuals

No comments

Asko D3152 Use and Care Guide Page 32

Comments to this Manuals

Related products and manuals for Dishwashers Asko D3152