Installation Instructions FI DishwasherINTRODUCTION ...
10 11STEP 2. ATTACHING THE ACCESSORY DOOR OR CUSTOM PANELFollow the separate instructions supplied with the dishwasher to attach the chosen accessory
10 11TYPE AThe door springs are on the sides of the dishwasher. If necessary, pull out the dishwasher and adjust the tension of the door springs. A go
12 135. Replace the back end of the spring by holding the spring at a right angle to the side of the dishwasher and pushing the end of the spring into
12 13STEP 4. CONNECTING ELECTRICITY, WATER, AND DRAIN1.THREE WAYS TO INSTALL DRAIN CONNECTIONSA) Typical connection to sink plumbing before trap (hig
14 15STEP 4. CONNECTING ELECTRICITY, WATER, AND DRAIN2. CONNECT WATER SUPPLY HOSEWARNING!Plumbing connections must comply with applicable sanitary, sa
14 15STEP 4. CONNECTING ELECTRICITY, WATER, AND DRAIN3. CONNECT THE PLUGEnsure that the power outlet is within the range of the power cable. Do not us
16 17STEP 5. CHECKING DISHWASHER FUNCTION AND FITSTEP 6. SECURING THE DISHWASHERTest the dishwasher with the Rinse & Hold program. Check that the
16 17STEP 6. SECURING THE DISHWASHER5. Check that the dishwasher’s steel feet are solidly placed on the floor. Make sure the dishwasher is not hanging
18 19STEP 7. ATTACHING THE TOE KICK (IF APPLICABLE)Insulation material1. xx2. 5. 6. 4. 3. 82x1"(25 mm)2x3/8"(10 mm)6x1-1/2"(38 mm)2x134
18 19NOTESCUSTOMER CARE CENTER 1-800-898-1879 • WWW.ASKONA.COM CUSTOMER CARE CENTER 1-800-898-1879 • WWW.ASKONA.COM492181 Install DW16 FI USA EN Rev 0
2 3TOOLS1) Phillips No. 2 screwdriver 2) Flat blade screwdriver3) Torx screwdriver size T 204) Adjustable wrenches (if you use copper fittings)5)
20INSTALLATION CHECKLISTASKO - DISHWASHERAppliance Installation Checklist• Remove packaging and check for cosmetic damages.• Remove the information pa
2 3• It is important that you closely follow the instructions provided here.• An incorrect or defective installation can lead to higher consumption
4 5D5526XXLFI, D5536XXLFI, D5536XXLFISOF, D5556XXLFIXXL DISHWASHERSUNIT DIMENSIONSU.S. MetricHeight (Adjustable) 33-7/8˝ to 35-7/8˝ 860 mm to 912 mm W
4 5D5526XLFI, D5536XLFIADA AND XL DISHWASHERSUNIT DIMENSIONSU.S. MetricHeight (Adjustable)* 32-3/8˝ to 34-1/4˝ 820 mm to 872 mm Width 23-5/8˝ 600 m
6 7ASKO XLADAFI dishwashers can be installed either with or without accessory fill strips depending on the type of installation. If the dishwasher cut
6 7STEP 1. FITTING THE DISHWASHER IN PLACE1. Be sure to remove the transport protection for the door when unpacking the dishwasher.
8 9STEP 1. FITTING THE DISHWASHER IN PLACE6. Adjust the front feet by turning them clockwise to raise or counterclockwise to lower the dishwasher. Lea
8 9STEP 1. FITTING THE DISHWASHER IN PLACE11. Adjust the back foot by turning the adjustment screw at the front clockwise. (Only models with front adj
Comments to this Manuals